Mix 8 ml (about 1/3 oz)(measurements on the bottle) or one 8 ml vial of Temprid FX with one gallon of water. Remember to use what you mix-within 24 hours. Adjust the spray pattern to a mist by turning the nozzle. A low fine mist is best for most spraying, but you may need to use a stream to get into some cracks and crevices. If you can't get into the cracks and crevices use one of the aerosols described below with it's crack and crevice tips to reach into these areas.
Insecticides might also have their work cut out for them: Entomologists have known that the common bedbug has built up resistance to some typical insecticides such as those containing certain pyrethroid chemicals like deltamethrin, according to Entomology Today. Deltamethrin apparently paralyzes an insect's nervous system, according to Cornell University.
Blood spots found on one’s sheets, bites and the presence of bed bug feces and cast skins are some of the indications of a bed bug infestation. Bites are commonly found on the parts of the body that are more likely to be exposed to bed bugs during sleep – the hands, neck, face, shoulders, legs and arms. While not always the case, bed bug bites are often grouped together in a small area and at times may occur in a line or a zigzag pattern. Bites normally look like small, flat or raised areas that may become inflamed, itchy, red or blistered. Bed bug bite reactions don’t always appear immediately after you’re bitten and may take a few days to begin causing symptoms. However, not everyone reacts to bed bug bites in the same manner.